To start with, the truck had to be completely stripped apart, so once that was done, it was time to start customizing it so it could once again drive and go to shows. The body was pulled off of the frame so the floor could be cut and raised 4 inches. This made sure that the rockers were good and solid on the ground. Before the body was bolted back on, the frame was painted and a 4-link was added along with a full set of bags.   
|
The rear frame clip was also completely rebuilt and a crazy tubular section was built. The floor of the bed was cut out perfectly around this section so it could be seen. The firewall was also smoothed and tubbed before the cab was set back on. Since the body was already being cut and welded, they decided to shave a few things to make for a cleaner bodyline.   
|
