 Now that all 5 bolts are removed on each headlight, the front crush panel will need to be removed. There are two 6mm Allen bolts under each headlight that will need to be removed to allow the crush panel to come off. 
|
Once the front crush panel is removed, you can simply unplug all the bulbs and pull the factory headlight forward to remove it. This leaves plenty of room for the new light to be installed. This is the comparison of the stock 2-piece set up and the new one-piece set up. Notice how the stock headlight will turn dull after a few years of use; the new lights will also clean up the front end as well. Now that you have removed everything and have both lights out, it is time to reverse all the previous steps and install the new lights. With these particular lights, you will only have 4 bolts to reinstall each light instead of 5. The new lights will simply need to be pushed in with the guide pins where the corner lights used to be and re-bolted. Here is what the final look will be. Something as simple and cheap as changing out your headlights can make all the difference in the world.
|
