For the next step you might need to turn the wheel into the wheel well of the side you are working on. This will give you a little more room to work. If you still have the stock bumper, you will need to remove a couple clips holding the plastic inner fender in. After this, there will be a Phillips head screw holding the end of each side of the bumper. Now here's where you will need that extra set of hands. Gently pull the front bumper forward and completely remove it from the car. Be careful not to lay it down on its face to avoid scratches. There will be two 10mm bolts on top of each headlight that will need to be removed.
|
There is also a 10mm bolt on the inner side of each light as well that will need to be removed. Next there is a 10mm bolt under where the corner light went, that will need to be removed. The next bolt is under the headlight towards the outside of the car. It is behind the crush panel. It is also a 10mm bolt and one per light.
|
